Diagnostic Procedure

INSPECTION START
Turn ignition switch to START.

Is any cylinder ignited?

Yes or No

Yes: GO TO 2.

No: GO TO 3.
CHECK OVERALL FUNCTION
With CONSULT-III
1. Start engine.
2. Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT-III.
3. Make sure that each circuit produces a momentary engine speed drop.
Without CONSULT-III
1. Start engine.
2. Listen to each fuel injector operating sound.
  Clicking noise should be heard.
  
  Fig 1: Checking Fuel Injector Operating Sound
  Courtesy of NISSAN NORTH AMERICA, INC.
OK or NG

OK: INSPECTION END

NG: GO TO 3.
CHECK FUEL INJECTOR POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect fuel injector harness connector (1).
  
  Fig 2: Identifying Fuel Injector Harness Connector
  Courtesy of NISSAN NORTH AMERICA, INC.
3. Turn ignition switch ON.
4. Check voltage between fuel injector terminal 1 and ground with CONSULT-III or tester.
  Voltage: Battery voltage
  
  Fig 3: Checking Voltage Between Fuel Injector Terminal 1 And Ground
  Courtesy of NISSAN NORTH AMERICA, INC.
OK or NG

OK: GO TO 5.

NG: GO TO 4.
DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors E3, F2
- 10A fuse
- Harness for open or short between fuel injector and fuse
  : Repair open circuit or short to ground or short to power in harness or connectors.
CHECK FUEL INJECTOR OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check harness continuity between fuel injector terminal 2 and ECM terminals 29, 30, 31, 32.
  Refer to WIRING DIAGRAM .
  
  Continuity should exist.
4. Also check harness for short to ground and short to power.
OK or NG

OK: GO TO 6.

NG: Repair open circuit or short to ground or short to power in harness or connectors.
CHECK FUEL INJECTOR
Refer to "COMPONENT INSPECTION ".

OK or NG

OK: GO TO 7.

NG: Replace malfunctioning fuel injector.
CHECK INTERMITTENT INCIDENT
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

: INSPECTION END