Component Inspection (ASCD Brake Switch)
- CHECK ASCD BRAKE SWITCH-I
- Turn ignition switch OFF.
- Disconnect ASCD brake switch harness connector.
- Check the continuity between ASCD brake switch terminals under the following conditions.
Terminals Condition Continuity 1 and 2 Brake pedal Fully released Existed Slightly depressed Not existed Is the inspection result normal?
YES >> INSPECTION END
NO >> GO TO 2.
- CHECK ASCD BRAKE SWITCH-II
- Adjust ASCD brake switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
- Check the continuity between ASCD brake switch terminals under the following conditions.
Terminals Condition Continuity 1 and 2 Brake pedal Fully released Existed Slightly depressed Not existed Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace ASCD brake switch. Refer to "EXPLODED VIEW ".