Data Monitor Mode
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
| Monitor item (Unit) | Remarks |
|---|---|
| BATTERY VOLT (V) | Displays the power supply voltage for EPS control unit. |
| TORQUE SENSOR (Nm) | Displays steering wheel turning force detected by torque sensor. |
| MOTOR CURRENT (A) | Displays the current value consumed by EPS motor.* 1 |
| MOTOR SIG (A) | Displays the current commanded value to EPS motor. |
| ASSIST TORQUE (Nm) | Displays assist torque of EPS motor being output by the electric power steering. |
| C/U TEMP (°C) or (°F) | Displays the temperature of the EPS control unit. |
| ASSIST LEVEL (%) | Normally displays 100%. In case of an excessive stationary steering, the assist curvature gradually falls. However, it return to 100% when left standing.* 2 |
| VEHICLE SPEED (km/h) or (MPH) | Vehicle speed is displayed from vehicle speed signal via CAN communication.* 3 |
| WARNING LAMP (On/Off) | EPS warning lamp control status is displayed. |
| ENGINE STATUS (Stop/Run) | Engine speed is displayed from engine status signal via CAN communication. |
*1: Almost in accordance with the value of "MOTOR SIG". It is not a malfunction though these values are not accorded when steering quickly.
*2: Normally displays 100%. In case of an excessive stationary steering, the assist curvature gradually falls. However, it returns to 100% when left standing.
*3: It is not a malfunction, though it might not be corresponding just after ignition switch in turned ON.