Component Inspection
- CHECK ACCELERATOR PEDAL POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check the voltage between ECM harness connector terminals as per the following condition.
ECM
Condition
Voltage
Connector
+
-
Terminal
E16
160
161
Accelerator pedal
Fully released
0.3 - 0.6 V
Fully depressed
1.95 - 2.4 V
153
154
Fully released
0.6 - 0.9 V
Fully depressed
3.9 - 4.7 V
Is the inspection result normal?
YES
INSPECTION END
NO
Replace accelerator pedal assembly. Refer to Removal and Installation .