Component Inspection

1. Turn ignition switch OFF.
2. Disconnect mass air flow sensor harness connector and reconnect it again.
3. Turn ignition switch ON.
4. Select "DATA MONITOR" mode with CONSULT.
5. Check the "INT/A TEMP SEN" indicates as per following condition.

   Monitor item	Condition		Value (Approx.)
   INT/A TEMP SEN	Temperature [ deg. C (deg. F)]	25 (77)	2.0 - 2.2 (V)

Is the inspection result normal?

YES

INSPECTION END

NO

Replace mass air flow sensor (with intake air temperature sensor). Refer to Exploded View .