Component Inspection

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector and ground.

   ECM				Condition		Voltage
   +		-
   connector	Terminal	connector	Terminal
   F24	15	E16	162	Selector lever	P or N	12 V
   					Other than above	0 V

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Remove transmission range switch. Refer to Exploded View .
2. Check transmission range switch. Refer to Inspection .

Is the inspection result normal?

YES

INSPECTION END

NO

Replace transmission range switch. Refer to Exploded View .