LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2021 >> Sentra S >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Steering Control System >> Basic Inspection >> Additional Service When Replacing EPS Control Unit >> Work Procedure >> Work Procedure (After Replacing EPS Control Unit)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure (After Replacing EPS Control Unit)

  1. CHECK "OPERATION LOG" 

    SYMBOL CONSULT

    Check "Operation Log" saved before replacing the EPS control unit, according to the procedure of "Programming" in CONSULT Operation Manual.

    NOTE: For the vehicle that the programming is to be performed, check if "Operation Log" of Vehicle Identification Number (VIN) is in Saved Data List.

    Is there an applicable Operation Log in the Saved Data List?

    YES

    GO TO 2.

    NO

    GO TO 3.

  2. PERFORM EPS CONTROL UNIT PROGRAMMING 

    SYMBOL CONSULT

    Perform EPS control unit programming, according to "Programming" of CONSULT Operation Manual. Refer to CONSULT Operation Manual.

    CAUTION: During programming, maintain the following conditions:
    • Ignition switch: ON
    • Electric load: OFF
    • Steering wheel: Not steering
    • Battery voltage: 12 - 13.5 V (Check the value displayed on the CONSULT screen.)
    • Vehicle speed: 0 km/h

    GO TO 5.

  3. READ IN EPS CONTROL UNIT PART NUMBER BY "FAST LINKED" 

    Obtain EPS control unit part number by NISSAN PARTS CATALOGUE GLOBAL Web-FAST, according to the procedure of 'FAST linked' in CONSULT Operation Manual. Refer to CONSULT Operation Manual.

    CAUTION: Be sure to select "FAST linked".
    NOTE: "FAST linked" allows an appropriate programming by obtaining ECU part number from NISSAN PARTS CATALOGUE GLOBAL Web-FAST even when the part number cannot be obtained from the old ECU used before replacing with a new one.

    GO TO 4.

  4. PERFORM PROGRAMMING (FAST LINKED) 

    SYMBOL CONSULT

    Perform EPS control unit programming according to the procedure of FAST linked in CONSULT Operation Manual. Refer to CONSULT Operation Manual.

    CAUTION: During programming, maintain the following conditions:
    • Ignition switch: ON
    • Electric load: OFF
    • Steering wheel: Not steering
    • Battery voltage: 12 - 13.5 V (Check the value displayed on the CONSULT screen.)
    • Vehicle speed: 0 km/h

    GO TO 5.

  5. PERFORM NECESSARY WORK 
    1. Perform adjustment of chassis control module (with built in steering angle sensor) neutral position. Refer to Work Procedure .
    2. Select "Self Diagnostic Result" mode of "EPS/DAST 3".
    3. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".

    End of work.

scientia non olet · About LEMON Manuals