LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 1990 >> Custom Cruiser >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Basic Fuel System Checks >> Fuel System Pressure Test (EFI) >> Fuel Pressure Check (Throttle Body Injection)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pressure Check (Throttle Body Injection)

  1. Relieve fuel pressure (if necessary). Remove air cleaner and plug thermal vacuum port on throttle body. When removing fuel line, always use 2 wrenches. Install Fuel Pressure Gauge (J-29658B or BT-8205) and Adapter (J-29658-85) in fuel line between steel line and flexible hose.
    NOTE: DO NOT pinch off fuel return line completely. DO NOT exceed pressure build-up of more than 32 psi (2.0 kg/cm2 ) on 2.5L "W" Body or 13 psi (.9 kg/cm2 ) on all other models as regulator may be damaged.
  2. Turn ignition on and observe fuel pressure reading. Fuel pressure should read 26-32 psi (1.8-2.2 kg/cm2 ) on 2.5L "W" Body (VIN R) or 9-13 psi (.6-.9 kg/cm2 ) on all other models . If no fuel pressure is indicated, go to step 5). If fuel pressure is okay but engine will not start, proceed to NO START DIAGNOSIS. If fuel pressure is present but is too high, go to step 4). If fuel pressure is present but is too low, gradually pinch off fuel return line to fuel tank.
  3. If fuel pressure remains low, check for plugged fuel filter or restriction in fuel delivery line. If filter is okay and no restrictions are present, replace fuel pump. If fuel pressure increases when return line is pinched, replace fuel pressure regulator.
  4. If fuel pressure is present but is higher than specification, check for restriction in fuel return line. If return line is not restricted, replace fuel pressure regulator.
  5. If no fuel pressure is observed, turn ignition off. Apply battery voltage to fuel pump test connector using a 10-amp fused jumper wire. For location of fuel pump test connector, refer to COMPONENT LOCATIONS in appropriate SYSTEM/COMPONENT TESTS article. Observe fuel pressure reading. If fuel pressure is still not evident, check wiring between test connector and fuel pump. If wiring is okay, replace fuel pump.
  6. If fuel pressure is present with voltage applied to test connector, test fuel pump relay and voltage supply to relay. Refer to the appropriate SYSTEM/COMPONENT TESTS article.
  7. After all repairs, allow fuel pressure to dissipate. Remove fuel pressure gauge and reconnect fuel line. Start engine and watch for fuel system leaks. For further details on fuel pressure testing, proceed to the appropriate SYSTEM/COMPONENT TESTS article.
scientia non olet · About LEMON Manuals