Mirror Does Not Manually Move Left Or Right

If diagnostic system check was performed, go to next step. If diagnostic system check was not performed, go to DIAGNOSTIC SYSTEM CHECK .
Turn ignition off. Ground memory seat diagnostic connector. Memory seat/memory mirror control module will chime once to indicate Mode 1 has been entered. Operate left outside mirror switch in all directions. Memory seat/memory mirror control module should chime once at each switch input. If any switch input does not cause a chime to sound, go to step 6). If all switch inputs cause a chime to sound, go to next step.
On left mirror, check for open in White wire between left outside mirror and memory seat/memory mirror control module Gray 6-pin connector C3. On right mirror, check for open in Red/White wire between right outside mirror and memory seat/memory mirror control module Gray 6-pin connector C3. If circuit is okay, go to next step. If circuit is not okay, go to step 8).
On left mirror, check for open in Light Blue wire between left outside mirror and splice S506. On right mirror, check for open in Gray wire between right outside mirror and splice S600. If circuit is okay, go to next step. If circuit is not okay, go to step 8).
Replace mirror left/right motor. To remove power mirror assembly, see MIRRORS - POWER article. Perform DIAGNOSTIC SYSTEM CHECK.
On left mirror, check for open in White wire between left outside mirror switch and memory seat/memory mirror control module Blue 32-pin connector C2. On right mirror, check for open in Red/White wire between left outside mirror switch and memory seat/memory mirror control module Blue 32-pin connector C2. If circuit is okay, go to next step. If circuit is not okay, go to step 8).
Replace left outside mirror switch. See appropriate POWER MIRRORS article. Perform DIAGNOSTIC SYSTEM CHECK .
Repair open in appropriate wire. See WIRING DIAGRAMS . Perform DIAGNOSTIC SYSTEM CHECK .