LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 1998 >> Cutlass Base >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Computer Relearn Procedures >> "C" Body >> Password Learn Procedure For Anti-Theft System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Password Learn Procedure For Anti-Theft System

  1. Password learn procedure must be performed if Powertrain Control Module (PCM), Pass-Key(R) III module, ignition lock cylinder, steering column assembly or ignition key are replaced. A password is communicated between Pass-Key(R) III module and PCM to provide engine operation. If PCM is replaced, the PCM must learn the password from the Pass-Key(R) III module.
  2. Insert a valid mechanical coded unlearned ignition key in the ignition switch. Place ignition switch in the RUN position. The SECURITY indicator light will come on for 10 minutes for the length of the auto learn timer. SECURITY indicator light is located on instrument panel, just below the fuel gauge.
  3. When auto learn timer expires and SECURITY indicator light goes off, place ignition switch in OFF position. Remove ignition key from ignition. Wait 10 seconds.
  4. Repeat steps 2) and 3) two more times. Insert the newly learned ignition key in ignition switch.
  5. Place ignition switch in RUN position. The SECURITY indicator light should remain off to indicate the ignition key was learned. If security indicator does not remain off, repeat procedure.
scientia non olet · About LEMON Manuals