Crankshaft Position (CKP) Sensor Variation Learn Procedure (5.7L)
- Procedure must be performed if any of the following have been done:
- EEPROM was reprogrammed.
- If crankshaft position sensor was removed or replaced.
- Powertrain Control Module (PCM) has been replaced.
- Install scan tool on Data Link Connector (DLC). Apply parking brake. Block rear wheels. Ensure hood is closed. Ensure transmission is in Park (A/T models) or Neutral (M/T models). Start engine and allow engine to idle until engine coolant temperature is at least 150°F (65°C). Ensure all accessories are off.
- Apply brakes. Ensure brakes remain applied during remaining duration of this procedure. Using scan tool, select and enable CKP sensor variation learn procedure.
- Gradually accelerate engine to 4000 RPM. Quickly release throttle to idle position once CKP sensor variation learn procedure is obtained and engine starts to decelerate. Once CKP sensor variation values are learned, the PCM will return engine control to the operator and engine will respond to throttle position.
- If CKP sensor variation learn procedure was not terminated, turn ignition off for at least 15 seconds. CKP sensor variation learn procedure is complete. If CKP sensor variation learn procedure was terminated, turn ignition off. Refer to Diagnostic Trouble Code (DTC) P1336 for additional diagnostic information. See the appropriate TESTS W/CODES article in ENGINE PERFORMANCE.