A/C Compressor Clutch Controls

NOTE: For A/C clutch circuit testing, see A/C-HEATER SYSTEM article in the AIR CONDITIONING & HEAT section. See wiring diagram in WIRING DIAGRAMS article for terminal and wire color identification.

To provide improved idle quality, improved Wide Open Throttle (WOT) performance and A/C system protection, the compressor clutch is controlled by PCM.

For proper control of cooling fans, compressor clutch and Idle Air Control (IAC) valve, a refrigerant pressure sensor is used. PCM uses signals provided by sensor to monitor high and low side refrigerant pressures. If PCM detects a fault in refrigerant pressure circuit, compressor clutch will be disabled.

The A/C clutch relay is controlled by PCM. This allows PCM to raise idle speed before engaging compressor clutch, or disable compressor clutch during WOT, high engine RPM, high power steering loads and hot engine restarts. PCM also disables compressor clutch if coolant temperature becomes excessive. To locate A/C clutch relay, see A/C CLUTCH RELAY LOCATION table.

A/C CLUTCH RELAY LOCATION

Application	Location
"H" Body	Center Rear Of Engine Compartment, Below Right-Side Maxifuse Block

WARNING: Vehicles may be equipped with a PCM using an Electrically Erasable Programmable Read Only Memory (EEPROM). When replacing PCM, the new PCM must be programmed.

NOTE: To help save diagnostic time, check for blown fuses or fusible links before proceeding with any testing. If fuses are blown, locate and repair short circuit before replacing fuses. Ensure all related relay and wire harness connections are clean and tight. Repair as necessary.