Test B: Lockout Function Inoperative
- If diagnostic system check was performed, go to next step. If diagnostic system check was not performed, see DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Turn ignition on, engine off. Enable window lockout function. Operate passenger power windows from passenger door power window switch. If power windows go up and down, go to next step. If power windows do not go up and down, check for intermittent problem.
- Check master switch lockout signal circuit (Dark Green wire) for short to battery voltage. If problem is found, repair as necessary and go to step 6 . If problem is not found, go to next step.
- Inspect for poor connections at harness connector of side window lockout switch. If problem is found, repair as necessary and go to step 6 . If problem is not found, go to next step.
- Replace side window lockout switch. After completing repair, go to next step.
- Operate system in order to verify repair.