Test D: Power Window Inoperative-Driver Door
- If diagnostic system check was performed, go to next step. If diagnostic system check was not performed, see DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Turn ignition on, engine off. Operate driver door power window from master switch. If power window operates correctly, check for intermittent problem. If power window does not operate correctly, go to next step.
- Operate passenger window from master switch. If window operates correctly, go to next step. If window does not operate correctly, see TEST C: ALL POWER WINDOWS INOPERATIVE .
- Access power window master switch. Using Connector Test Adapter Kit (J-35616-A), connect test lamp between left front power window motor UP circuit terminal "A" (Dark Blue wire) and DOWN circuit terminal "E" (Tan wire) at master switch connector C2. See Figure . Operate left front power window in up and down directions. If test lamp illuminates in both directions, go to next step. If test lamp does not illuminate in both directions, go to step 6 .
- Test power window motor feed left front UP (Dark Blue wire) and DOWN (Brown wire) circuits for an open or short to ground. If problem is found, repair as necessary and go to step 8 . If problem is not found, go to step 7 .
- Replace left power window master switch. After completing repair, go to step 8 .
- Replace left front power window motor. See WINDOW REGULATOR MOTOR under REMOVAL & INSTALLATION. After completing repair, go to next step.
- Operate system in order to verify repair.