LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 2002 >> Intrigue GL >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Repair Instructions >> Traction Control Switch Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the traction control switch into front floor console trim plate by pressing into place until fully seated and retaining clips are fully engaged.
  2. Connect the traction control switch wiring harness connector to the traction control switch.
    Fig 1: Install Traction Control Switch Into Front Floor Console Trim Plate
    G01757564Courtesy of GENERAL MOTORS CORP.
  3. Align the front floor console trim plate to the front floor console and carefully press the retaining clips into the correct mounting holes in the front floor console.
  4. Close the front floor console cupholder.
    NOTE: Refer to FASTENER NOTICE
  5. Install the 2 retainers that attach the front floor console trim plate to the front floor console.

    Tighten 

    Tighten the 2 retainers to 2 N.m (18 lb in).

  6. Close the front floor center console armrest.
  7. Verify the repair. Refer to Diagnostic System Check - ABS .
    Fig 2: Install Retainers That Attach Front Floor Console Trim Plate To Front Floor Console
    G01757565Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals