Diagnostic Procedures
- Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM.
- Reprogram PCM using correct software. See PROGRAMMING . Is action complete? If yes, go to step 4. If no, go to next step.
- Replace PCM. Program replacement PCM. See PROGRAMMING .
- Use scan tool to clear DTCs. Turn ignition off for 30 seconds. Start engine. Operate vehicle within the Conditions for Running the DTC. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step 3.
- Using scan tool, observe the stored information, Capture Info. Does scan tool display any DTCs that you have not diagnosed? If yes, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.