Installation Procedure

Fig 1: Removing/Installing Shift Lock Actuator

Courtesy of GENERAL MOTORS CORP.

In drive position, depress the shift lock actuator button and realign into the shiftier lever.
Push lever to neutral.

NOTE: Refer to Fastener Notice .

Install the top screw through the lever slot.
Tighten: Tighten the BITSI screw to 1.65 N.m (1.2 lb ft).
Shift lever to low.
Install the screw at the rear of the shiftier assembly.
Tighten: Tighten the BITSI screw to 1.65 N.m (1.2 lb ft).

Fig 2: Disconnecting/Connecting Shift Lock Actuator Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (3).

IMPORTANT: After assembling the shift lock actuator, turn the ignition forward but do not start (auxiliary position) and attempt to pull the lever from park with and without the brake pedal depressed to verify there is no gear access without the brake pedal depressed.

IMPORTANT: Ensure the key cannot be removed from the ignition unless both the shiftier is in PARK and the shift knob button has been depressed.

Fig 3: Removing/Installing Center Console Assembly

Courtesy of GENERAL MOTORS CORP.

Verify the shift lock actuator functions properly.
Install the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.