LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Plymouth >> 1984 >> Conquest Automatic >> Repair and Diagnosis >> Engine Performance >> System >> ECI System >> Testing & Diagnosis >> Component Testing >> Control Relay
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Relay

  1. Control relay is mounted on top of ECU. Disconnect electrical harness and test continuity between terminals 1 and 7 and 3 and 7. If there is no continuity, relay is good. If continuity is measured, replace control relay.
  2. Apply battery voltage to terminals 8 (positive) and 4 (negative). Measure continuity between terminals 3 and 7. If continuity is measured, relay is good. If not, replace relay.
  3. Apply battery voltage across terminals 6 (positive) and 4 (negative) while testing continuity between terminals 1 and 7. If there is continuity, relay is good. If not, replace relay.
  4. Apply battery voltage across terminals 5 (positive) and 2 (negative) while testing continuity between terminals 1 and 7. If there is continuity, relay is good. If not, replace relay.
scientia non olet · About LEMON Manuals