LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Plymouth >> 1990 >> Colt Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - PFI >> TDC Sensor (DOHC Engines) >> Test No. 2
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test No. 2

  1. Turn ignition on. On Colt and Colt 200 1.6L, check for battery voltage at crank angle connector terminal No. 3.
  2. On all models, if battery voltage is present, go to step 3. If battery voltage is not present, repair open condition in supply wire between ignition switch and crank angle connector.
  3. Turn ignition switch off. On Colt and Colt 200 1.6L, connect ohmmeter between ground and crank angle connector terminal No. 2.
  4. On all models, if there is continuity, go to step 5. If there is no continuity, repair open condition in ground wire between crank angle connector and ground.
  5. Check pin condition of crank angle connector. If necessary, repair pin connections. If pin condition is okay, remove distributor. Check condition of connector at bottom of distributor. If necessary, repair pin connections, If connector is okay, replace crank angle and TDC sensor assembly.
scientia non olet · About LEMON Manuals