LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Plymouth >> 1990 >> Laser Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Relays & Solenoids >> Relays >> Control Relay (1.8L)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Relay (1.8L)

  1. Control relay is located on right side of center console. Disconnect control relay connector. Using an ohmmeter, check if approximately 95 ohms of resistance is present between control relay terminals No. 3 and 5, and terminals No. 2 and 5. See Fig 1 .
  2. Using an ohmmeter, ensure approximately 35 ohms of resistance is present between control relay terminals No. 6 and 7. Ensure there is infinite resistance between terminals No. 1 and 4, and between terminals No. 2 and 4.
  3. Conenct positive ohmmeter lead to terminal No. 6 and negative lead to terminal No. 8, ensure there is infinite resistance. Using an ohmmeter, connect positive ohmmeter lead to terminal No. 8 and negative lead to terminal No. 6, zero ohms resistance should exist.
  4. While grounding terminal No. 6 and applying battery voltage to terminal No. 8, ensure there is zero ohms resistance between terminals No. 2 and 4.
  5. While grounding terminal No. 6 and applying battery voltage to terminal No. 7, ensure there is zero ohms resistance between terminals No. 1 and 4. Replace control relay if it does not test as described.
    Fig 1: Control Relay Terminal Identification (1.8L)
    G90F06293Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals