Throttle Position Sensor
- TPS is mounted to throttle body, at end of throttle shaft. Disconnect TPS connector. See Fig 1 . Using ohmmeter, measure total resistance between specified TPS connector terminals. See TPS CONNECTOR TERMINAL IDENTIFICATION table. If resistance is not 3500-6500 ohms, replace TPS.
- Using an analog (needle-type) ohmmeter, measure variable resistance between specified TPS connector terminals. See TPS CONNECTOR TERMINAL IDENTIFICATION table.
- Operate throttle valve from closed to wide open throttle. If resistance does not change smoothly within 3500-6500 ohms throughout throttle valve movement range, replace TPS.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
TPS CONNECTOR TERMINAL IDENTIFICATIONApplication Terminal No. Total Resistance 1 & 4 Variable Resistance 2 & 4