Driver Door Fails To Unlock

NOTE: After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS. Unless instructed otherwise in test step, reconnect any disconnected connectors.

Turn ignition off. Disconnect Remote Keyless Entry (RKE) module connector. Using an ohmmeter, check resistance between ground and RKE module connector terminal No. 5, driver door unlock driver circuit (Pink/Black wire). If resistance is less than 1000 ohms, repair Pink/Black wire for short to ground. If resistance is 1000 ohms or more, replace RKE module. See REMOTE KEYLESS ENTRY (RKE) MODULE under REMOVAL & INSTALLATION.