Programming Ignition Keys To SKIM

Connect scan tool to Data Link Connector (DLC). DLC is located below driver's side of instrument panel. See Figure . Using scan tool, select THEFT ALARM, SKIM then MISC. Select PROGRAM IGNITION KEYS. Obtain 4-digit Personal Identification Number (PIN) from vehicle owner or manufacturer.
NOTE: If 3 attempts are made incorrectly to enter PIN, secured access mode will be locked out for one hour. To exit lock out mode, leave ignition switch in ON position for one hour. Ensure battery voltage is maintained with battery charger, if necessary.

NOTE: A maximum of 8 keys can be learned to each SKIM. Once a key is learned to SKIM, key cannot be transferred to another vehicle.
Enter secured access mode by entering PIN code for vehicle. Obtain ignition keys to be programmed from customer. Select MISC, then ERASE ALL CURRENT IGN KEYS. Program all ignition keys by following instructions on scan tool.