Trim Adjustment
-
NOTE: Make adjustment with full fuel tank, or equivalent weight.
Raise vehicle and support axle. Remove shock absorber line at control valve. Connect a fill valve to air supply line. Inflate shock absorbers to 8-15 psi. Jounce vehicle to equalize suspension.
- Connect test gauge to shock absorber adapter on control valve and attach an air pressure source (80-110 psi) to gauge. Loosen height control valve lever adjusting nut. Hold overtravel lever in exhaust position until air escapes from exhaust port.
- Slowly move overtravel lever toward neutral position and point a minimum air bleed through exhaust port. Tighten nut. A slight continuous air bleed should be noticeable. Lower vehicle to floor and inflate system through service valve on compressor.