Engine Controls - Sensor Operating Range Charts: Introduction

Sensor operating range information can help determine if a sensor is out of calibration. An out-of-calibration sensor may not set a trouble code, but it will cause driveability problems.

NOTE: Unless stated otherwise in test procedure, perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance.

COOLANT TEMPERATURE SENSOR RESISTANCE ⁽¹⁾

Temperature °F (°C)

Ohms

212 (100)

177

194 (90)

241

176 (80)

332

158 (70)

467

140 (60

667

122 (50)

973

113 (45)

1188

104 (40)

1459

95 (35)

1802

86 (30)

2238

77 (25)

2796

68 (20)

3520

59 (15)

4450

50 (10)

5670

41 (5)

7280

32 (0)

9420

23 (-5)

12,300

14 (-10)

16,180

5 (-15)

21,450

-4 (-20)

28,680

-22 (-30)

52,700

-40 (-40)

100,700

⁽¹⁾	Measure resistance between terminals of sensor.

FUEL INJECTOR SOLENOID RESISTANCE TEST

Test Point	Ohms
Between Injector Terminals	1.2

IDLE AIR CONTROL VALVE (IACV) RESISTANCE TEST

Wire Color (Connector Terminal)	Ohms
Green/White (A) & Green/Black (B)	20
Blue/White (C) & Blue/Black (D)	20

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR VOLTAGE TEST ⁽¹⁾

Altitude Feet (Meters)

Volts

1000-2000 (305-610)

3.6-5.2

2000-3000 (610-914)

3.5-5.1

3000-4000 (914-1219)

3.3-5.0

4000-5000 (1219-1524)

3.2-4.8

5000-6000 (1524-1829)

3.0-4.6

6000-7000 (1829-2133)

2.9-4.5

7000-8000 (2133-2438)

2.8-4.3

8000-9000 (2438-2743)

2.6-4.2

9000-10,000 (2743-3048)

2.5-4.0

⁽¹⁾	Measure voltage at circuit No. 432 (White/Green wire) and circuit No. 450 (Black/White wire) with ignition on and engine off.

O2 SENSOR VOLTAGE TEST ⁽¹⁾

Condition

Volts

Lean

Rich

⁽¹⁾	Measure voltage between ground and O2 sensor terminal with engine running.

THROTTLE POSITION SENSOR (TPS) VOLTAGE TEST ⁽¹⁾

Application

Volts

Closed Throttle

.4-1.25

Full Throttle

4.8

⁽¹⁾	Measure voltage at circuit No. 417 (Dark Blue wire), with circuit No. 452 (Black wire) grounded and a 5-volt reference supplied to circuit No. 416 (Gray wire).