Fuel Injector(s)

Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See INJECTOR RESISTANCE SPECIFICATIONS .

INJECTOR RESISTANCE SPECIFICATIONS⁽¹⁾

Application

Ohms

2.5L (VIN R)

1.6

3.1L (VIN T)

12.0-12.4

3.4L (VIN X)

12.0-12.4

3.8L (VIN L)

⁽²⁾

⁽¹⁾	Injector resistance specification is at 140°F (60°C).

⁽²⁾	Information not available at time of publication. Solenoid should have resistance; however, infinite resistance indicates an open injector winding.

NOTE: If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing PFI INJECTOR BALANCE TEST.