Removal & Installation
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Use correct fastener in correct location. Replacement fasteners must be correct part number for application. Fasteners requiring replacement or fasteners requiring use of thread locking compound or sealant are identified in service procedures. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage fastener. Use correct tightening sequence and specifications when installing fasteners in order to avoid damage to part and systems.
Disconnect negative battery cable. Remove left instrument panel insulator. Disconnect BCM harness connectors. Push up on module, and pull bottom away from and out of mounting bracket slot. See Fig 1. Remove module from vehicle. To install, reverse removal procedure. Ensure appropriate relearn procedures are performed. See BODY CONTROL MODULE under PROGRAMMING.