Rear Integration Module

If Drivers Information Center (DIC) ON and OFF lights are illuminated, settings for that feature will not be able to be changed. When DIC ON and OFF lights are illuminated, this indicates a module did not respond to cluster with personalization information when "Feature Programming" mode was entered.

If DIC ON and OFF lights are blank (not illuminated), cluster has received invalid data from module(s) in question and settings for that feature will not be able to be changed using DIC. This will occur when 2 different modules are involved in same setting and modules do not agree as to whether feature is ON or OFF. This could also occur if a module sends an invalid state to cluster.

Scan tool will have to be used to toggle feature setting for module(s) in question so that they agree or contain valid states. Once they agree, DIC can be used to change settings if needed. Use following steps to personalize module:

1. Turn ignition switch to ON position. Ensure vehicle is in "P" position. If equipped with memory, press appropriate memory button "1" or "2" located on drivers door panel, prior to programming. Press INFO button one or more times until "Feature Programming" prompt appears on DIC.
2. Press ON/OFF button to enter "Feature Programming" mode. Press down arrow on INFO button to select personalization feature to be programmed. Press ON/OFF button to turn personalization feature ON or OFF. To exit, press INFO RESET button and turn ignition switch to OFF position.