System Operation Check

NOTE: Because Retained Accessory Power (RAP) will time out, steps 1) through 4) must be performed within 10 minutes after cycling ignition and without opening doors

With doors closed, vehicle in Park (A/T) or parking brake applied (M/T), cycle ignition switch to RUN position, then back to OFF position. Press LOCK button on either door lock switch. Doors should lock.
Press UNLOCK button on door lock switch. Doors should unlock. Illuminated entry should activate.
Press rear compartment lid release switch twice within 5 seconds. Rear compartment lid should release. Illuminated entry should activate.
Open door. Press LOCK switch on door. Doors should lock, unless last door closed locking is active, then doors will lock after last door is closed.
Exit vehicle, close door and hatch. Press door UNLOCK button on RKE transmitter. Driver door should unlock and interior light illuminate.
Press door UNLOCK button on RKE transmitter a second time within 5 second of first press. Passenger door should unlock. Interior lights should remain illuminated for 40 seconds from first press of UNLOCK button, or until ignition is turned to RUN position.
Wait for interior light to go out. Press LOCK button on RKE transmitter. Doors should lock.
Press rear compartment lid release button on RKE transmitter. Rear compartment lid should release and interior light should illuminate for 40 seconds.

If RKE system does not operate as described, check for Diagnosic Trouble Codes (DTC). See SELF-DIAGNOSTIC SYSTEM . If no DTCs are present, see SYMPTOM INDEX table under SYMPTOM TESTS for diagnostic procedure.