Electronic Brake Control Module & Brake Pressure Modulator Valve Assembly: Installation
CAUTION:
Ensure brake pipes are correctly connected to BPMV. If brake pipes are switched, wheel lock-up will occur and personal injury may result. The only two ways this condition can be detected are by using a scan tool or by performing an anti-lock stop.
NOTE:
Ensure correct fasteners are used in correct locations. Do not use paints, lubricants, or corrosion inhibitors unless specified.
- To install, reverse removal procedure. Ensure brakelines are installed in original locations. Ensure EBCM harness connector tab is locked down. Tighten bolts, nuts and brakelines to specification. See TORQUE SPECIFICATIONS .
- If NEW BPMV assembly is being installed, ensure shipping plugs are removed from valve openings. Refill brake master cylinder reservoir, bleed brakes and check for leaks. See BLEEDING BRAKE SYSTEM .
- Using scan tool, perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING and check if any DTCs have been set. Diagnose and repair as necessary.