LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls Self-Diagnostics >> Diagnostic Tests >> DTC P0125: Engine Coolant Temperature Excessive Time To Enter Closed-Loop Fuel Control >> Diagnostic Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedures

  1. Perform powertrain diagnostic system check. See POWERTRAIN DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check, go to next step.
  2. Check if any ECT related DTCs are set. Diagnose affected DTCs first. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no ECT related DTCs are set, go to next step.
  3. Turn ignition off. Disconnect ECT sensor harness connector. Connect a fused jumper wire between ECT sensor harness connector terminals. Turn ignition on, with engine off. Using scan tool, observe ECT sensor temperature. If ECT sensor temperature is greater than 280°F (138°C), go to step  7. If ECT sensor temperature is not greater than 280°F (138°C), go to next step.
  4. Turn ignition off. Connect jumper wire between ECT sensor harness connector terminal "B" (Yellow wire) and a known-good ground. Turn ignition on, with engine off. Using scan tool, observe ECT sensor temperature. If ECT sensor temperature is greater than 280°F (138°C), go to next step. If ECT sensor temperature is not greater than 280°F (138°C), go to step  6.
  5. Turn ignition off. Repair high resistance or open in Orange/Black wire between ECT sensor harness connector terminal "A" and PCM harness connector C1 terminal No. 13. After repairs, go to step  10.
  6. Turn ignition off. Repair high resistance or open in Orange/Black wire between ECT sensor harness connector terminal "A" and PCM harness connector C1 terminal No. 13. After repairs, go to step  10.
  7. Turn ignition off. Remove ECT sensor. Suspend ECT sensor and a thermometer in a pan of water. Place the pan on a burner or hot plate. Check resistance of ECT sensor through the specified range of temperatures. See ENGINE SENSORS & SWITCHES in appropriate SYSTEM & COMPONENT TESTING article. If resistance and temperature closely matches the specified range, go to next step. If resistance does not match the specified range, go to step  9.
  8. Reinstall ECT sensor. Diagnose and repair engine cooling system problem.
  9. Replace ECT sensor. After replacing sensor, go to next step.
  10. Turn ignition on, with engine off. Using scan tool, clear DTCs. Turn ignition off for 30 seconds. Operate vehicle within the conditions for running this DTC. See CODE ENABLE CRITERIA . If DTC runs and passes, go to next step. If DTC resets, go to step  2.
  11. Using scan tool, observe stored information and CAPTURE INFO. If scan tool displays any undiagnosed DTCs, diagnose affected DTCs. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no DTCs are displayed, system is okay.
scientia non olet · About LEMON Manuals