LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Body Control Modules) >> Removal & Installation >> Remote Control Door Lock Receiver >> Removal (Impala)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal (Impala)

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove windshield pillar garnish molding from clip retainers on upper side rail. See Figure. Slide roof leg of windshield pillar garnish molding out from under center pillar trim panel. Remove windshield pillar garnish molding from windshield pillar. Remove windshield pillar garnish molding from front door carpet retainer by pulling up and back. Remove windshield pillar garnish molding. Remove upper side rail clip retainers if damaged during removal of windshield pillar garnish molding, remove screw and replace retainer from upper side rail.
  2. Starting at right side of windshield, carefully lift upwards on defroster grille in order to release retainers. See Figure. Continue working to left until all of retainers are released. Disconnect Daytime Running Lights (DRL) sensor from defroster grille. See Figure. Remove defroster grille.
  3. Disengage Remote Control Door Lock Receiver (RCDLR) retainers. Disconnect RCDLR electrical connectors. Remove RCDLR. See Figure.
scientia non olet · About LEMON Manuals