LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 739 (Engine Control System) >> Crankshaft Position (CKP) Sensor Removal/Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position (CKP) Sensor Removal/Installation: Removal

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cover.
  2. Disconnect the negative battery cable.
  3. Remove the plug hole cover.
  4. Perform the following procedure for easier access.
    1. Remove the front tire (RH).
    2. Remove the splash shield.
  5. Disconnect the CKP sensor connector.
  6. Remove the installation bolt and remove the CKP sensor.
Fig 1: Removing/Installing Crankshaft Position Sensor
G00972608Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals