Removal (Aztek 3.4L): Notes
- Remove the battery ground (negative) cable from the battery.
- Rotate and secure the engine forward. See Rotating the Engine for Service Access .
- Remove the generator B+ terminal nut.
- Remove the generator B+ lead.
- Remove the generator electrical connector.
- Remove the drive belt from the generator.
- Remove the generator front bolt.
- Remove the generator rear bolts.
- Remove the generator from the generator bracket and position the generator above the drive axle.
- Remove the drive belt tensioner.
- Remove the generator bracket.
- Remove the power steering pipes from the power steering pipe retainer.
- Remove the fuel pressure test port (schrader valve) cap from the fuel injector rail.
- Remove the power steering pump and reposition the power steering pump in front of the timing chain cover in order to provide access for the generator.
- Remove electrical harness from retainer on right fender well and position aside.
- Remove the generator from the vehicle.
IMPORTANT:
Do not disconnect the power steering pipes from the power steering pump.