Diagnostic Procedures
- Perform I/M system check. See INSPECTION/MAINTENANCE SYSTEM CHECK . After performing I/M system check, go to next step.
- Ensure vehicle is within the conditions for running this test. See ENABLE CRITERIA . Turn off all accessories (e.g., A/C, blower fan, etc.). Start and allow engine to idle for 2 minutes. In order for Active Test to run, vehicle must operate in the following conditions:
- Accelerate at part throttle to 45 MPH and maintain speed for 3 minutes or until I/M system status indicator updates to YES.
- Using scan tool, monitor I/M SYSTEM STATUS. If CATALYST SYSTEM STATUS is YES, go to step 5. If CATALYST SYSTEM STATUS is not YES, go to next step.
- Using scan tool, observe DTC information. If scan tool indicates any failed DTCs, diagnose affected DTCs. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If scan tool does not indicate any failed DTCs, go to next step.
- Using scan tool, observe the Not Ran Since Code Cleared display. Determine which of DTCs required for a YES status has not run. Enter DTC number in Specific DTC menu of scan tool. Operate vehicle within conditions for running the DTC. See ENABLE CRITERIA . Repeat procedure until scan tool indicates that diagnostic test has run. Repeat for any additional required DTCs that have not run. Using scan tool, observe I/M system status display. If AIR system status updates to YES, go to next step. If AIR system status does not update to yes, see DIAGNOSTIC AIDS .
- Using scan tool, check for DTCs. If scan tool indicates any DTCs are set, diagnose affected DTCs. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no DTCs are displayed, system is okay.