Body Control Module (BCM) Programming/RPO Configuration: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
If the module is replaced, the module must be programmed prior to performing the Passlock Learn procedure.
- Ensure that the following conditions exist in order to prepare for BCM programming:
- The battery is fully charged.
- The ignition switch is in the RUN position.
- All accessories are turned OFF.
- All modules and devices are connected and functioning properly before programming.
- Follow the SPS instructions on the Techline Terminal and scan tool to program the BCM.
- If the BCM fails to accept the program, perform the following steps:
- Inspect all BCM connections.
- Verify that the SPS Techline Terminal and scan tool have the latest software version.