LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery >> Repair Instructions >> Battery Positive Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

Fig 1: Installing Battery Positive Cable To Vehicle
G01745890Courtesy of GENERAL MOTORS CORP.
  1. Install the battery positive cable to the vehicle.
  2. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
    NOTE: Refer to FASTENER NOTICE .
  3. Install the battery positive cable and nut to the starter motor BAT terminal.

    Tighten

    Tighten the nut to 10 N.m (89 lb in).

  4. Install the battery positive cable to the conduit.
  5. Install the battery cable conduit to the conduit retainers.
    Fig 2: Installing Battery Positive Cable To Battery
    G01745891Courtesy of GENERAL MOTORS CORP.
  6. Install the lower radiator baffle. Refer to RADIATOR AIR BAFFLE ASSEMBLIES AND DEFLECTORS .
  7. Lower the vehicle.
  8. Connect the battery positive cable to the generator. Refer to GENERATOR .
  9. Install the battery positive cable and nut to the underhood electrical center.

    Tighten 

    Tighten the nut to 10 N.m (89 lb in).

  10. Install the battery positive cable and bolt to the battery.

    Tighten 

    Tighten the bolt to 16 N.m (12 lb ft).

  11. Install the battery ground (negative) cable to the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure  .
scientia non olet · About LEMON Manuals