Section 722 (HVAC System)
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Symptom Troubleshooting
- Foreword
- Troubleshooting Index
- No. 1 Insufficient Air (Or No Air) Blown From Vents
- No. 2 Amount Of Air Blown From Vents Does Not Change
- No. 3 Air Intake Mode Does Not Change
- No. 4 Temperature Control With Climate Control Unit
- No. 5 Windshield Fogged
- No. 6 Air From Vents Not Cold Enough
- No. 7 No Cool Air
- No. 8 Noise While Operating A/C System
- Refrigerant System
- Basic System
- HVAC Basic System Location Index
- A/C Unit Removal/Installation
- A/C Unit Disassembly/Assembly
- Expansion Valve Removal/Installation
- Evaporator Inspection
- Heater Core Inspection
- Airflow Mode Main Link Removal/Installation
- Rear Heat Duct Removal/Installation
- A/C Compressor Removal/Installation
- Condenser Removal/Installation
- Condenser Inspection
- Receiver/Drier Removal/Installation
- Refrigerant Lines Removal/Installation
- Control System
- HVAC Control System Location Index
- Air Intake Actuator Removal/Installation
- Air Intake Actuator Inspection
- Blower Motor Removal
- Blower Motor Installation
- Blower Motor Inspection
- Resistor Removal/Installation
- Resistor Inspection
- Magnetic Clutch Disassembly/Assembly
- Magnetic Clutch Adjustment
- Magnetic Clutch Inspection
- Evaporator Temperature Sensor Removal/Installation
- Evaporator Temperature Sensor Inspection
- Refrigerant Pressure Switch Removal/Installation
- Refrigerant Pressure Switch Inspection
- Climate Control Unit Removal
- Climate Control Unit Installation
- Climate Control Unit Disassembly/Assembly
- Climate Control Unit Wire Adjustment
- Climate Control Unit Inspection
- Fan Switch Inspection
- Technical Data
- Service Tools