Body Control Module (BCM) Programming/RPO Configuration: Introduction
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
The procedures below are designed to set-up the body control module (BCM) correctly during BCM related service. Before you start, read these procedures carefully and completely.
Important: The following procedures must be followed:
- Read this procedure carefully and completely.
- The BCM will not function properly if the Setup New BCM procedure is not performed.
- Perform the PROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS
in Theft Deterrent after successfully finishing the Setup New BCM procedure. If the PROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS
in the Theft Deterrent procedure is not performed after a BCM replacement, one of the following conditions will occur:
- The vehicle will not be protected against theft by the PASSLOCK system.
- The engine will not crank nor start.