Removal Procedure

Important:  You must perform the new body control module (BCM) setup when replacing the BCM. Refer to BODY CONTROL MODULE (BCM) PROGRAMMING/RPO CONFIGURATION  .

1. Disconnect the negative battery cable.
2. Remove the console accessory wiring junction block. Refer to CONSOLE ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT .
3. Rotate the BCM retaining lever (1) to release the BCM from the console accessory wiring junction block.
4. Remove the BCM (2) from the console accessory wiring junction block.
   Fig 1: Rotating Body Control Module Retaining Lever For Releasing

   Courtesy of GENERAL MOTORS CORP.