Installation Procedure
- Verify all primers and urethane adhesive are within expiration dates.
Important: Use care when applying the prep, clear #1, to the window. This primer dries almost instantly, and may stain the viewing area of the window if not applied evenly.
- Use a new dauber in order to apply glass prep, clear #1, to the channel area approximately 13 mm (1/2 in) to the upper edge of the window.
- Wipe the glass primed area immediately with a clean lint-free cloth.
- Shake the glass primer, black #2, for at least 1 minute.
- Use a new dauber in order to apply glass primer, black #2, to the top edge of the window.
- Apply a small bead of urethane adhesive (2) between the window (1) and the pinch-weld.
- Reinstall the window reveal molding.
- Start from the loose area and hand-press the reveal molding into place over the edge of the window.
- Run warm water over the reveal molding in order to speed the setup time of the urethane adhesive.
- Tape should be applied in order to retain the reveal molding to the window. This will maintain a flush fit with the body.
- The tape is to be removed after 6 hours.