LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> On-Vehicle Testing >> Engine Electrical Diagnostic System Check >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

  1. Perform battery inspection test. See BATTERY TESTING & INSPECTION  under ON-VEHICLE TESTING. After performing inspection, go to next step.
  2. Connect scan tool to Data Link Connector (DLC). Turn ignition switch to RUN position. If scan tool powers up, go to next step. If scan tool does not power up, see BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
    3. NOTE: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
  3. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool. Rotate the ignition switch through all positions while observing the Class 2 Power Mode parameter. The ignition switch parameter reading should match the ignition switch position for all switch positions. If reading is as specified, go to next step. If reading is not as specified, see appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  4. Turn ON the ignition, with the engine OFF. Attempt to communicate with each of the following modules on the class 2 serial data circuit:
    • Body Control Module (BCM).
    • Instrument Panel Cluster (IPC).
    • Powertrain Control Module (PCM).
    The scan tool should communicate with all modules on the class 2 serial data circuit. If communication is as specified, go to next step. If communication is as not specified, see appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  5. Select display DTC function for each module. Record all displayed DTCs, status of displayed DTCs and module that set DTC. If DTCs are displayed, go to next step. If no DTCs are displayed, repair charging system by symptom. See SYMPTOM INDEX  table under SYSTEM TESTS.
  6. If scan tool does not display DTCs which begin with "U", go to next step. If scan tool displays DTCs which begin with "U", perform appropriate test. See BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  7. If scan tool displays DTCs B1000, perform appropriate. See DIAGNOSTIC TROUBLE CODE DEFINITIONS in BODY CONTROL MODULES article. If scan tool displays any other DTCs which begin with "B", see DIAGNOSTIC TROUBLE CODE DEFINITIONS  .
scientia non olet · About LEMON Manuals