Reverse Servo: Removal
- Remove the throttle body air inlet duct. Use a large flat-blade tool in order to depress the reverse servo cover. See Fig 1
.
- Use a small flat-blade tool in order to remove the retaining ring. See Fig 2
. Use a small flat-blade tool in order to pull the "O" ring seal out through the slot in the case. Use side cutting pliers in order to cut the servo cover "O" ring seal.
- Depress the reverse servo cover, grasp one end of the cut seal and pull the seal out of the servo cover.
- Use a large flat-blade tool in order to depress the reverse servo cover, grasp one end of the cut seal and pull the seal out of the servo cover.
- Remove the reverse servo cover. See Fig 2
. Remove the servo assembly. Remove the servo spring.
Courtesy of GENERAL MOTORS CORP.
Courtesy of GENERAL MOTORS CORP.