LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2003 >> Sunfire Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Remote Keyless Entry System) >> Programming >> PASSLOCK(tm) LEARN PROCEDURE >> 10-Minute Learn Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

10-Minute Learn Procedure

WARNING: This page is about a different car, the 2002 Pontiac Sunfire, 2002 Chevrolet Cavalier, 2001 Pontiac Sunfire, and 2001 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Techline terminal with current Service Programming System (SPS) software is required to perform this procedure.
  1. Connect scan tool with Techline terminal to Data link Connector (DLC). DLC is located on lower left side of instrument panel, near steering column. Using scan tool, select REQUEST INFORMATION under SERVICE PROGRAMMING. Disconnect scan tool from DLC.
  2. On Techline terminal, select THEFT MODULE RE-LEARN under SERVICE PROGRAMMING. Disconnect scan tool from Techline terminal. Connect scan tool to DLC. Turn ignition switch to RUN position. Select VTD system RE-LEARN under SERVICE PROGRAMMING.
  3. Attempt to start vehicle. Vehicle will not start. Monitor THEFT SYSTEM indicator in instrument cluster. After 10 minutes, THEFT SYSTEM indicator will turn off. Vehicle is now ready to relearn Passlock(tm) sensor data code or password when ignition switch is cycled again from LOCK to START position.
    4. CAUTION: You must turn ignition switch to LOCK position before attempting to start vehicle.
  4. Turn ignition switch to LOCK position and wait 5 seconds. Start vehicle. Vehicle has now learned password. Using scan tool, clear any Diagnostic Trouble Codes (DTC). History DTCs will self-clear after 100 ignition switch cycles.
scientia non olet · About LEMON Manuals