Test Description

The numbers below refer to the step numbers in the diagnostic procedures.

1. 2
   
   If there is a fault in either the Crankshaft Position (CKP) sensor or Camshaft Position (CMP) sensor circuits, the ignition system can malfunction. Repair the cause of a DTC P0335 or DTC P0340 first.
2. 3
   
   If there is a fault in the electrical circuits between the PCM and the ignition coil assemblies, a DTC P1300-P1315 will set. Use the DTC P1300-P1315 diagnostic procedure to repair the ignition system failure.
3. 7
   
   This step checks for a condition that can cause a loss of spark, even though the test in step  4 indicated that there was good spark.
4. 10
   
   This step checks whether the engine will start and run. A repair that has been performed leading to this step may only have been a contributing cause of a no start condition. Returning to the Engine Cranks but Does Not Run diagnostic procedure will locate additional causes of the no start condition.