Installation Procedure

Install the rear object alarm detection module.

Fig 1: View Of Rear Object Alarm Detection Module
Courtesy of GENERAL MOTORS CORP.
Install the electrical connector to the module.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the bolts that secure the rear object alarm detection module.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Secure the top of the quarter trim over the bolts.
Install the cargo tie-down loops from the rear quarter trim.
Install the rear liftgate sill.

Fig 2: Identifying Rear Liftgate Sill
Courtesy of GENERAL MOTORS CORP.
Install the storage compartment. Refer to Storage Compartment Replacement - Rear (Rendezvous) in Interior Trim.
Install the upper trim from the second and third row pillars.

Fig 3: View Of Upper Trim From Second & Third Row Pillars
Courtesy of GENERAL MOTORS CORP.
Install the guide loop bolts from the second and from the third row seat belts.

Fig 4: Locating Guide Loop Bolt
Courtesy of GENERAL MOTORS CORP.
Close the guide loop covers to the left rear seat belt.

Fig 5: Identifying Guide Loop Covers From LH Rear Seat Belt
Courtesy of GENERAL MOTORS CORP.
Return the second and the third row seats to their upright positions.

Fig 6: Aligning Second Row Seats Forward
Courtesy of GENERAL MOTORS CORP.