LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Body Control System) >> Repair Instructions >> Body Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: You must perform the new body control module (BCM) setup when replacing the BCM. Refer toBody Control Module (BCM) Programming/RPO Configuration .
  1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the left instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
  3. Disconnect the BCM electrical connectors (2,3,4).
  4. Remove the BCM (1).
    5. Fig 1: Body Control Module & Electrical Connectors
    GM614333Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals