Installation Procedure
IMPORTANT:
Ensure that the slide pin is properly located into the bracket hole.
- Slide the pin, part of air cleaner assembly, into the bracket hole on the left strut tower.
IMPORTANT: Verify full engagement of the inlet onto the resonator neck and no contact of the air cleaner to the strut tower.
- Position and install the air cleaner inlet over the resonator neck.
- Install the push in retainer from the air cleaner to the battery tray.
- Install the relay center and the push in retainer.
- Connect the relay battery feed cable into the upper air cleaner cover retaining clips.
- Install the battery, refer to Battery Replacement
and connect the battery cables.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Connect the air cleaner outlet duct.
Tighten: Tighten the air cleaner outlet duct clamps to 5 N.m (44 lb in).