LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Sunfire Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L (L61) Introduction >> Repair Instructions >> Idle Air Control (IAC) Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Lubricate the IAC valve seal with clean engine oil.
  2. Install the IAC valve into the throttle body.
    Fig 1: View Of Idle Air Control (IAC) Valve & Throttle Position (TP) Sensor
    GM783168Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install a new screw when replacing the IAC valve.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the IAC valve screw.

    Tighten:  Tighten the IAC valve screw to 3 N.m (27 lb in).

  4. Connect the IAC valve harness connector (1).
  5. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  6. Reset the IAC valve pintle using the following procedure:
    1. Turn ON the ignition, with the engine OFF.
    2. Turn OFF the ignition for 10 seconds.
    3. Start the engine and check for proper idle operation.
scientia non olet · About LEMON Manuals