LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Rear Parking Assist System >> Repair Instructions >> Object Alarm Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Rear Object Alarm Detection Module
    GM785378Courtesy of GENERAL MOTORS CORP.
  1. Install the rear object alarm detection module.
  2. Install the electrical connector to the module.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts that secure the rear object alarm detection module.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Secure the top of the quarter trim over the bolts.
    5. Fig 2: Identifying Rear Liftgate Sill
    GM786746Courtesy of GENERAL MOTORS CORP.
  5. Install the cargo tie-down loops from the rear quarter trim.
  6. Install the rear liftgate sill.
  7. Install the storage compartment. Refer to Storage Compartment Replacement - Rear (Rendezvous) in Interior Trim.
    8. Fig 3: View Of Upper Trim From Second & Third Row Pillars
    GM786752Courtesy of GENERAL MOTORS CORP.
  8. Install the upper trim from the second and third row pillars.
    9. Fig 4: Locating Guide Loop Bolt
    GM786753Courtesy of GENERAL MOTORS CORP.
  9. Install the guide loop bolts from the second and from the third row seat belts.
    10. Fig 5: Identifying Guide Loop Covers From LH Rear Seat Belt
    GM786759Courtesy of GENERAL MOTORS CORP.
  10. Close the guide loop covers to the left rear seat belt.
    11. Fig 6: Aligning Second Row Seats Forward
    GM786757Courtesy of GENERAL MOTORS CORP.
  11. Return the second and the third row seats to their upright positions.
scientia non olet · About LEMON Manuals